Table of Contents
Advertisement
WARNING: Electrical hazard
Before performing any work on this product,
disconnect and lock out electrical power
sources to prevent injury from unexpected ener-
gization or start-up. A lockable device has been
provided to isolate this product from potentially
hazardous electricity.
WARNING: Improper installation, oper-
ation, or servicing may result in
equipment damage or personal injury.
This equipment should only be installed, adjust-
ed, and serviced by qualified technical person-
nel who are familiar with the construction, oper-
ation, and potential hazards of this type of
machine.
All wiring, disconnects, and fuses should be
installed by qualified electrical technicians in
accordance with electrical codes in your region.
Always maintain a safe ground. Do not operate
the equipment at power levels other than what
is specified on the machine serial tag and data
plate.
1
Be sure the main power is disconnected and
the saw is locked out
lock out the main power source before opening the unit or
servicing.
2
Turn the main power disconnect to the off
position
before opening the electrical enclosure on the
back of the saw or the back of the control. This is a safety
device to prevent you from opening the doors if the power
is still on.
Main power
safety
disconnect
UGE058/0803
. Always disconnect and
C
HECKING
E
LECTRICAL
C
ONNECTIONS
continued on the next page
M
CTS Saw
AINTENANCE
5-7
Advertisement
Table of Contents
