Table of Contents
Advertisement
P
OSITIONING
CTS S
THE
3-4
I
NSTALLATION
1
Move the saw into position.
tion downstream of the belt puller.
AW
Saw
2
Determine the best distance
the CTS Saw.
3
Align the saw with the extrusion line.
4
Measure the centerline height
it exits the extrusion die. Adjust all equipment on the
extrusion line (sizing tank, cooling tanks, belt puller, and
saw) to this height.
CTS Saw
CAUTION: Lifting
To avoid personal injury or damage to the saw,
lift the saw using a forklift or hoist with straps
that have been positioned at the saw's center of
gravity.
For flexible products, the saw should be as close as
possible to the puller.
For rigid products, leave enough space to allow
the product to flex during the cutting cycle. In some
cases, it may be necessary to allow 6-8 feet between
the puller and saw.
continued on the next page
Place the saw in posi-
from the belt puller to
of the extrudate as
UGE058/0803
Advertisement
Table of Contents
