Table of Contents
Advertisement
T
S
HE
AW
C
ONTROL
4-2
O
PERATION
IMPORTANT: Before applying power, ensure that the
SAW BLADE UP and TABLE FORWARD valves are
closed (fully clockwise), and that the saw blade is not
installed on the cut-off saw.
Connect the electrical line cord to a source of power com-
1
patible with the nameplate on the saw cut-off saw.
Connect the air supply to the FRL (filter-regulator-lubricator)
2
on the saw.
3
If the optional dust collector was purchased, install and con-
nect the dust collector
4
Turn the main disconnect switch to the ON position; the
POWER ON light will illuminate.
5
Press Start or (if equipped with Dust Collector) turn Dust
Collector power "ON" first and then press saw motor "START"
6
Check the motor rotation. If the motor rotation is incorrect:
Reverse the connections at the AC plug end.
7
Once the rotation is correct, disconnect the power, and
install the blade on the cut-off saw.
8
Make sure that the FRL is set for 6--65 PSI
NOTE: Setting the FRL to higher level will only release
air from the system. The CTS is equipped with a relief
valve that is preset for approximately 70 PSI. The CTS
is equipped with a relief valve that is preset for approxi-
mately 70 PSI. The relief valve is in place to protect the
air components from damage due to excessive air pres-
sure.
9
Press MANUAL CUT
Adjust the TABLE FORWARD speed control to match the
10
approximate line speed.
11
Adjust the SAW BLADE UP speed control to the desired
blade travel speed.
12
Set the blade height limit by adjusting the collar on the lifting
rod (located on the table surface)
CTS Saw
continued on the next page
UGE058/0803
Advertisement
Table of Contents
