Electrical Operation - Conair CTS 5 User Manual

The operation of the saw consists of an automatic sequence of
events.
1
To start the saw the main power must be on and the appro-
priate air supply to the machine. With the power on, the
control panel will have the power on light illuminated.
2
To start the saw motor, push the start button.
Once the saw motor is started, push the yellow manual cut
button and the machine will start its automatic cycle. The
clamps will come down and the table will begin to travel
away from its home position. Immediately after this hap-
pens, the saw pivot assembly will raise the blade up
through the table slot until it reaches its up limit switch.
Upon reaching this switch, the saw pivot will immediately
return down through the table, the clamps will raise and the
table will return to its home position, completing one
cycle.
IMPORTANT: An important reminder is that the speed
settings of the pneumatic flow controls will affect the
cycle time of the machine. The flow controls must be set
properly to a compromise between cycle time and cut
quality. Flow control settings should be adjusted at this
time and fine-tuned during the initial phase of the saw
operation.
UGE058/0803
E
LECTRICAL
O
PERATION
CTS Saw
4-7
O
PERATION