Table of Contents
Advertisement
Installation Site Requirements
Power Supply Redundancy Planning
Because chassis system components consume varying amounts of electrical power,
Enterasys recommend consulting the module power specifications in "Power Supply
Redundancy" on page 2‐2 to guide you in installing the proper number of power supplies
for your configuration.
Installation Site Requirements
The DC power supply must be installed in an Enterasys Matrix™ X chassis located in a
Restricted Access Location (RAL). This location should only be accessible by people who
have been trained or are technically competent enough to be aware of potential risks of
accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or
locked cabinet meet this requirement.
1-4 DC Power Supply Installation
Warning: Install this module on an Enterasys Matrix™ X chassis that has been installed in
a Restricted Access Location only. Access to the equipment by users must be restricted
through the use of a tool or lock and key or other means of security and is controlled by
the authority responsible for the location.
Advertencia: Instalar este modulo en un Enterasys Matrix™ X chassis que ha sido
localizado en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem Enterasys Matrix™ X chassis,
wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich zu den
Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen Sicherungen
geschützt und durch einen Verantwortlichen kontrolliert werden.
Advertisement
Table of Contents
Need help?
Do you have a question about the Matrix X Router and is the answer not in the manual?