Crosswater Palmero US-B3CCS Installation Instructions

Palmero Basin
US-B3CCS
Installation Instructions
Introduction
This basin has been fully inspected throughout the production
process and only leaves our factory after a 15-stage QC process.
Carefully remove the basin from the box and check that all parts have
been supplied.
Before beginning installation of the basin, please check for any
damage that may have occurred during transport. Note: Damage
claims cannot be made during or after installation.
It is recommended to remove the protective packaging film after
installation of the basin. Improper installation shall result in loss of
warranty in case of damage caused by impacts or rubbing against
rough surfaces.
Prior to installing the basin prepare a connection of water inlet/outlet.
The installation procedure of the basin may differ from that described
in the installation instructions depending on where the the basin is to
be located.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
It is recommended to use US-BSW0101 waste flow products with this
basin.

Tools required

Tape
measure
Safety Set
glasses square

Installation notes

The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
Store the basin in a safe place until beginning installation to avoid any
damage.
Assemble the basin on a mat to protect against damage to the basin
surface.
Avoid getting cement, grit, sand or masonry products on to the
surface.
Protect and cover the basin during the installation period to prevent
damage from occurring.
IMPORTANT: Turn off the main water supply before connecting to
any existing pipework or doing any maintenance.
Please check for any hidden pipes and cables, electric or otherwise,
before drilling holes in a wall or floor.

Dimensions

Weight - 12lbs
13-3/4"
10-5/8"
Pencil Spirit
level
1-3/4" dia
21-5/8"
18-1/2"
Silicone
sealant