Crosswater US-L1 Installation Instructions

Claw Bathtub Feet
US-L1
Installation Instructions

Introduction

The claw feet have been fully inspected throughout the production
process and only leaves our factory after a 15-step QC process.
Carefully remove the claw feet from the box and check that all parts
have been supplied.
Before beginning installation, please check for any damage that may
have occurred during transport.
Note: Damage claims cannot be made during or after
installation.
Improper installation shall result in loss of warranty in case of
damage caused by impacts or rubbing against rough surfaces.
IMPORTANT: Please read these instructions carefully before
beginningand retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.

Parts supplied

x4 x4 x4

Tools required

Tape Safety
measure glasses
x4 x8
8mm Adjustable
drill wrench

Installation notes

The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor. Assemble
the bathtub on a mat to protect against damage to the tub surface.
Note: Bathtub diagrams shown are for reference only.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise, before drilling holes in a wall or floor.
x4 x4 x4
Flat head Pencil
screwdriver
x4 x8
Spirit Silicone
level sealant
x1