Intended Use; Safety Instructions; Care - tams elektronik B-6 Manual

Booster B-6

1.3. Intended use

The booster B-6 is intended for use in digital model railway layouts as specified in the
instructions. Any other use is not in accordance with the intended use and will result in the
loss of the warranty claim. Intended use also includes reading, understanding and following all
parts of the instructions. The booster is not intended to be used by children under the age of
14.

1.4. Safety instructions

Improper use and non-observance of the instructions can lead to incalculable hazards. Prevent
these dangers by carrying out the following measures:

Use the booster and the power supply unit only in closed, clean and dry rooms. Avoid
humidity and splash water in the environment. After condensation has formed, wait two
hours for acclimatisation before use.

Disconnect the booster from the power supply before carrying out wiring work.

Only plug the mains plug of the power supply unit into properly installed and fused earthed
sockets.

Heating of the booster and the power supply unit during operation is normal and harmless.
Keep a distance of at least 20 cm between the sides, the top and the back to surrounding
surfaces to allow unhindered air exchange and to predect the units from overheating.

Do not expose the units to high ambient temperatures or direct sunlight. Observe the
information on the maximum operating temperature in the technical data.

Regularly check the operational safety of the units, e.g. for damage to the connection
cables or damage to the housing.

If you notice damage or if malfunctions occur, switch off the supply voltage immediately.
Send in the booster and/or the power supply unit for inspection.

Dangerous voltages occur inside the power supply unit. Therefore, never open the housing
of the power supply unit.

1.5. Care

Do not use any cleaning agents to clean the booster and the power supply unit. Only wipe the
units dry. Disconnect the units from the power supply before cleaning.
6 | Getting started
tams elektronik