WIB-11 | WIB-12 | WIB-13 English Table of contents 1. Getting started .................11 2. Safety instructions..............12 3. Safe and correct soldering............13 4. Operation overview..............14 5. Technical specifications..............15 6. Mounting the carriage lighting............15 7. Check list for troubleshooting.............17 8. Guarantee bond................18 EU declaration of conformity.............18...
English WIB-11 | WIB-12 | WIB-13 Required materials For connecting the carriage ligthing you need: an electronic soldering iron (max. 30 Watt) or a regulated soldering iron with a fine tip and a soldering iron stand, a tip-cleaning sponge, ...
WIB-11 | WIB-12 | WIB-13 English Thermal danger A hot soldering iron or liquid solder accidentally touching your skin can cause skin burns. As a precaution: use a heat-resistant mat during soldering, always put the hot soldering iron in the soldering iron stand, ...
4. Operation overview Possibilities of use The carriage lighting WIB-11 to -13 can be connected directly to a vehicle´s current collector or the function output of a digital vehicle decoder. For the power supply analogue a.c. or d.c. transformers or digital boosters can be used.
WIB-11 | WIB-12 | WIB-13 English 5. Technical specifications Supply voltage Digital voltage of the central unit or analogue d.c. or a.c. voltage Minimum supply voltage approx. 6 V (yellow LEDs) 7 V (white LEDs) Maximum supply voltage 24 Volt...
Page 8
English WIB-11 | WIB-12 | WIB-13 to each of the two parts. In order to supply the 8 LEDs of a whole PCB (or the 7 LEDs of a shortened PCB), normally one capacitor or goldcap is sufficient. Choose an electrolytic capacitor or a goldcap with a capacity as high as possible.
WIB-11 | WIB-12 | WIB-13 English Connecting the remaining segment The after shortening remaining segment with one remaining LED can be used for instance as a driver´s cab lighting or as lighting for the passengers´s entrance. The remaining segment should be connected to the power supply via a series resistor of minimum 1 kOhm.
This product conforms with the EC-directive 2012/19/EG on waste electrical and electronic equipment (WEEE). The Tams Elektronik GmbH is registered with the WEEE-no. DE 37847206, according to. § 6 sect. 2 of the German electro regulations from the responsible authority for the disposal of used electro equipment.