tams elektronik B-6 Manual page 32

Booster B-6
Display
ot.
--
rE
| || |
alternating with
– –
Adjusting the Brightness of the RGB LEDs
You can adjust the brightness of the RGB LEDs:
→ section 5.2 "Main track programming", input values for CV 7: 90 ... 98 (90 = minimum
brightness | 98 = maximum brightness)
32 | Operation
Colour
of the RGB LEDs
Meaning
orange-red flickering:
"Overtemperature" / overheating
Immediately disconnect the booster from the
power supply. Eliminate the cause of the
overheating (obstruction of air exchange, very
high ambient temperature or direct sunlight).
As soon as the booster has cooled down, you
can put it back into operation.
blue flashing: BiDiB-Identify
The B-6 reports to the PC control software via
BiDiB (BiDiB-Identify).
To stop sending the signal, press the button
again until the RGB LEDs light up green or red
again.
violet rising and falling:
After the reset, the B-6 automatically switches
back to standard operation.
Update
The B-6 automatically switches back to
standard operation after the update.
tams elektronik
Reset