GE TiP LOGIQ 400 Quick Start Manual page 26

Color Flow Mode (CFM) Controls (cont'd)
Adjustments for...
Decrease Motion 1.
Increase the VELOCITY SCALE.
Artifact
2.
Increase W.E. Cancel.
Improve Sensitivity 1.
Increase GAIN.
2.
Decrease VELOCITY SCALE.
3.
Increase ACOUSTIC OUTPUT.
4.
Switch Penet. on and High Resoltn
on.
5.
Decrease W.E. Cancel.
6.
Increase Frame Average (this
allows gain to increase).
7.
Increase Packet Size.
8.
Reduce SCAN AREA SIZE to
smallest size reasonable.
9.
Optimize focal zone position.
Decrease Color Flow 1.
Decrease GAIN.
Bleeding
2.
increase VELOCITY SCALE.
3.
Decrease Display Thrshld.
Quick Start 20
All manuals and user guides at all-guides.com
Color Flow Mode Optimization
Do the Following... Adjustments for...
Eliminate Aliasing
1.
Increase VELOCITY SCALE.
2.
Lower BASELINE SHIFT.
Improve Frame 1.
Decrease color window using
Rate/Flow Dynamics
SCAN AREA SIZE width.
2.
Exit COLOR FLOW to reduce
B-Mode image width (use SCAN
AREA SIZE).
3.
Decrease DEPTH.
4.
Increase VELOCITY SCALE (if
flow state allows it).
5.
Decrease Frame Average.
LOGIQ
2237879–100 Rev. 0
Do the Following...
t
400 Quick Start Guide