Advertisement
Table of Contents
RECORD OF SATISFACTORY CONDITION (the "RECORD)
After installing the bollard, make a record of its appearance. Describe in writing the
condition of the bollard, anchoring hardware and the anchoring surface around the
bollard, operating mechanisms (if applicable), as well as the location of each label,
tag, decal, etc. Take photographs of all frame elements: mounting plate, bollard
body, cap, and label(s). Add the photos to the record. These documents and photos
are a record of the unit in satisfactory condition.
INSPECTIONS AND MAINTENANCE
Compare your observations to the
item is in satisfactory condition. Remove the bollard from service unless every
component is in satisfactory condition. Cosmetic changes, like recently damaged
paint/powder coat, are not changes from satisfactory condition. However, touchup
paint must be applied to all affected areas as soon as damage occurs. Exposed metal
rusts and rust could compromise the integrity of the metal. Contact
to order replacement parts. Contact information appears on the cover page of this
instruction manual.
At least once per month:
1. Check the surface of the product for dirt or other matter. Clean the bollard.
2. Examine anchoring hardware. Replace damaged, worn, or corroded hardware.
Confirm that the bollard is solidly anchored to the (concrete) ground surface.
Replace all anchoring hardware that is not solidly attached to the ground. If the
bollard wobbles, tighten loose anchor bolts. Install the bollard in another location if
wobble cannot be eliminated in the present location.
3. Examine all parts of the bollard for cracks, corrosion/rusting, impact damage, metal
fatigue, and other forms of damage. Apply touchup paint to all exposed metal.
4. Check all labeling. Replace labels that are damaged or not easily readable. See
LABELING DIAGRAM
5. Examine the whole structure for severe rusting/metal erosion, rot, thinned regions. If
rusting is purely superficial, remove the rust/corrosion with a steel bristle brush or steel
wool. Clean the affected area and apply touchup paint. If rusting, rot, or thinning
has weakened the material, contact
LABELING DIAGRAM
Label content and location are subject to change so your product might not be
labeled exactly as shown. Compare the diagram below with the RECORD. If you have
any questions about labeling, contact
damaged, missing, or not easily readable (e.g. faded). To order replacement labels,
contact
the
https://www.vestil.com/page-parts-request.php
parts and/or service by calling (260) 665-7586 and asking the operator to connect you
to
TECHNICAL
SERVICE.
Table of Contents
Rev. 3/1/2023
(below).
technical
service
Label 366
Label 551
Copyright 2023 Vestil Manufacturing Co
RECORD
to determine whether the inspected
TECHNICAL SERVICE
TECHNICAL
SERVICE. Replace all labels that are
and
parts
department
Alternatively, request replacement
.
Model
BOL-2-##
BOL-4.5-##
BOL-5.5-##
BOL-6.5-##
BOL-8.5-##
BOL MANUAL
TECHNICAL SERVICE
for advice.
online
Label
Quantity
551
2
366
1
366
1
366
1
366
2
at
Page 6 of 7
Advertisement
