Intended Use; Type Plate; Symbols On The Device - Würth 0510 955 915 Translation Of The Original Operating Instructions

Intended use

The device is intended solely for the charging of
rechargeable 12/24 V lead-acid batteries and
12.8 V lithium batteries that meet the following
specifications:
Lead-acid batteries (wet, gel, MF and AGM)
• 12 V: 50-400 Ah
• 24 V: 25-200 Ah
Lithium batteries (LiFePO4)
• 12.8 V: 30-200 Ah
The charger is used to charge rechargeable batter-
ies/accumulators (hereinafter both referred to just
as batteries). Non-rechargeable (primary) batteries
must not be connected. The compliance with all
information in these operating instructions also forms
part of the intended use. Any use beyond this or
other types of use are classified as misuse and can
result in dangerous situations.
The user is liable for damage in the event
of improper use.
Device elements (fig. I)
Overview
1 LED error messages
2 LED charging state display
3 12 V Normal LED
4 12 V Cold/AGM LED
5 24 V Normal LED
6 24 V Cold/AGM LED
7 Jump Charge button
8 Jump Charge LED
9 LED (on/off)
10 12 V Lithium LED
11 12 V Advanced AGM LED
12 13.6 V Power Supply LED
13 12 V Recover LED
14 Mode button

Type plate

Symbols on the device

Compliance with EU directives
Before first use of the device, careful-
ly read through all of the operating
instructions and store them safely for
future use.
The device belongs to protection
class II. It has high-strength insula-
tion and therefore does not require
protective earthing.
IP44
The device is dustproof and splash-
proof.
The device has a T3 15 A 230 V
fuse
Do not dispose of the device with
domestic waste! Dispose of the de-
vice via an approved waste disposal
company or via your local authority
waste disposal facility. Observe the
currently valid regulations.
In case of doubt, contact your waste
disposal facility.
GS mark of conformity
15