Table of Contents
Advertisement
3.3
RECOVERY
On recovery, data can be extracted to PC via the 3m Y lead. This procedure is covered
in the separate software manual for DataLog Express.
To prolong the lifetime of the instrument the following procedures should be carried out
once the instrument has been recovered:
Remove any significant growth from the instrument. A high pressure water jet or
•
stiff (not metal) brush is suitable – a hard toothbrush is ideal.
Remove any significant growth from the pressure sensor port. Take care not to
•
introduce any sharp objects onto the sensor face – this may result in sensor
damage.
Check instrument for signs of damage.
•
Rinse the instrument in fresh water
•
Dry the instrument if possible, paying particular attention to the sensors and
•
connector.
Repack the instrument in the transit case provided.
•
M
WLR Hardware Manual
IDAS
Page 13
© Valeport Limited
0730877D.doc
Advertisement
Table of Contents
