Troubleshooting Procedures; None Of The Components Operate (E.g., Pump, Light); Pump Does Not Operate; Poor Jet Action - Jacuzzi J-200 Owner's Manual

J-200
5.
A Pump Appears to be Stuck ON - M034: Water may be overheated.
POWER DOWN THE SPA. DO NOT ENTER THE WATER. Contact
your dealer or service organization.
6.
A Pump Appears to have been Stuck ON when spa was last powered
- M035: POWER DOWN THE SPA. DO NOT ENTER THE WATER.
Contact your dealer or service organization.
15.0

Troubleshooting Procedures

In the event your Jacuzzi spa is not working the way it should, please first
review all the installation and operating instructions in this manual and check
the message on the panel display. If you are still not satisfied it is working
properly, please follow the appropriate troubleshooting instructions below.
Note: If any of the supply cords to the accessories are damaged,
they must be replaced by authorized service personnel. Contact your
authorized Jacuzzi dealer or qualified service technician. Always insist
on genuine Jacuzzi replacement parts.
15.1

None of the Components Operate (e.g., Pump, Light)

Check the following:
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Contact your authorized Jacuzzi dealer or qualified service technician.
15.2

Pump Does Not Operate

Press the JETS 1 Button:
1. If no water movement is detected, make sure power is going to
the spa and check the water level. If it does not solve the problem,
contact your authorized Jacuzzi dealer.
2. The main pump operates but no water flows to jets. Pump may not
be properly primed (page 20). This can happen after the spa is
drained and refilled.
15.3

Poor Jet Action

1. Make sure jets are in the full open "on" position (page 30).
2. Press the JETS 1 button to make certain pump #1 is on.
3. Open all air controls to their full-on position (counterclockwise).
4. Check for dirty filter. Clean, if necessary (Section 12.1, page 40).
15.4

Water is Too Hot

Reduce thermostat setting.
54