Adjusting And Setting The Time; Invert The Display; Locking The Spa - Jacuzzi J-200 Owner's Manual

J-200
D. Ready-in-Rest Mode
When the spa is in a Rest Mode " " and the Jets
Pump 1 button is pressed, the spa will heat to either
the set temperature or for one hour. Both icons will be shown on the
display. After the 1-hour time out and automatic clean up cycle the spa
will return to Rest Mode.
11.3

Adjusting and Setting the Time

The time on the spa can be programmed. This is needed in order for the
spa to run during a programmed filter cycle.
• The default time is for 12:00 noon.
• The default setting is for a 12-hour configuration. See Preference
settings for selecting a 12-hour or 24-hour display, page 38.
• The time information is not stored. If power is cut to the spa you
must reset the time.
A. Set Time
Note: If no button is pressed within 5 seconds of each
selection the screen will revert back to the Main Menu and the current
settings will remain active.
1. Press 3 times until you get to the "SET TIME/TIME" Menu. The
display will scroll "SET TIME" at start up or anytime the power to the
spa is turned off and on.
2. Press or
3. The display will change from "SET TIME" to
flashing. Press
corner, an
4. Press to set the minutes. The display will change from
. The minutes will be flashing. Press
minutes. Press
5. To check the time, press the Menu button until you get to the Time
Menu. The display will alternate between "TIME" and the current time.
11.4

Invert the display

From the Main Menu, press the
option. Press
Press to accept the change and return to the main.
11.5

Locking the Spa

Certain functions and features can be locked to prevent
unauthorized use.
• Temperature lock: The set temperature and programming settings
cannot be adjusted. Jets can be activated. The following menus can
be accessed: FLIP, LOCK, UTIL, INFO, and FALT LOG, if equipped.
When trying to adjust the temperature, "LOCK" will appear.
34
to prepare the system for changes.
or to adjust the hour. In the upper right-hand
or will display. This indicates either AM or PM.
to accept the change and return to the main.
or to invert the display from
button until you reach the "FLIP"
. The hour will be
or to adjust the
to .
to