Management Of Functions Via Control Panel; Setting The Time; Displaying The Time; Water Heating - Jacuzzi Experience Alimia Installation Manual

clock
pump 1
pump 2
blower
spotlight
MANAGEMENT OF FUNCTIONS
VIA CONTROL PANEL
All spa functions are managed by the control panel on the tub, as
are the respective settings/programming.
When the system is powered on, the display shows the time
alternating with the temperature in the tub.
If the electric heater is in operation, the corresponding symbol
also appears: .
I

SETTING THE TIME

For correct management of the water filtering and use of the
energy savings mode, the current time must be set.
Press the "Clock"
time will be displayed, the hour digit will flash, and the respec-
tive symbol will appear on the display.
Use the keys "Up"
Hold the keys down for rapid change.
Then press the "Clock"
will start flashing.
Proceed as described previously.
Press the "Clock"
and exit programming mode.
NOTES
- If no key is pressed for 5 seconds, you will exit the proce-
dure and any settings will not be memorized.
- There is a back-up battery that keeps the time up-to-date even
when the system is powered off.

Displaying the time

To display the time, press the "Clock"
filtering cycle
adjustment
temperature
heater
energy
saving
panel lock
key for about 5 seconds. The current
and/or "Down" to set the hour.
key to set the minutes, which
key again to memorize the set values
key .
Light
Clock
I

WATER HEATING

The water in the tub is heated by the electric heater located
in the tub compartment. Temperature adjustment is managed
by specific parameters to be set from the control panel.
Press the key "Up"
show the currently memorized temperature, and the respective
symbol will appear.
Press the key "Up"
displayed value from a minimum of15 °C to a maximum of 40
°C (59÷104 °F).
To show the temperature of the water in the tub again, do not
touch any key for about 5 seconds.
I

ADJUSTMENT OF WATER TEMPERATURE

The water is heated by a tubular electrical heater. Do not set
excessively high water temperature, i.e. over the limit of 40°C.
The recommended temperature is 35-36°C.
PLEASE NOTE !
The heater is de-activated if the pumps and/or blower are ac-
tivated and the maximum permitted consumption is exceed
(the symbol will flash on the display). In this case, if you
need to heat the water, the system will activate the heater 5
minutes after consumption has decreased enough to allow it
to be switched on.
I

Temperature unit of measure

The temperature scale is set to °C. It can be changed to °F as fol-
lows:
Press and hold the "Light"
til the message "cFn" appears.
If necessary, use the "Up"
scroll the menu until you see the message "cFn". Press the
"Light" key again to confirm the option.
Now insert the password 123 as follows:
30
Filter Blower Pump 1 Up
Instant Clear Econo Pump 2 Down
or "Down" . The display will
or "Down" again to change the
key for about 12 seconds, un-
and/or "Down" keys to