Table of Contents
Advertisement
PRE-INSTALLATION
1.4. Use Qualified Technicians
A Licensed Plumber, Electrician, Contractor and/or Certified Water Treatment Specialist may be re-
quired to install the AIRaider System in accordance with the installation instructions. All wiring must
be performed in accordance with the National Fire Protection Association's (NFPA)"National Electri-
cal Code, Standard #70"-current edition for all commercial and industrial work. All wiring must be
performed by a qualified and licensed electrician. Check your Local and State Code and Licensing
requirements. Failure to follow the instructions may lead to poor system performance and/or possible
system damage.
NOTICE: The Installation must comply with all applicable Local and State Codes and NFPA
National Electrical Code, Standard #70!
1.5. Full Water Test
A full Water Sample Analysis must be performed* to determine the quality of the water that requires
treatment. In many water supplies, contaminants other than radon are present and may need to be
pre-treated in order for the AIRaider to work properly. The AIRaider System is only effective for the
removal of radon and some other VOCs. The Aeration Process employed by the AIRaider System and
other radon removal systems can worsen problems due to iron or manganese contaminants in the
water supply.
*For optimal removal of radon or other VOCs, other contaminants such as iron or manganese must
be removed before the water supply enters the AIRaider System. Installation of a sediment filter is
highly recommended as a pre-treatment of the water supply. The filter should be routinely cleaned
or replaced.
FAILURE TO REMOVE OTHER CONTAMINANTS INCLUDING SEDIMENT CAN REDUCE
SYSTEM EFFECTIVENESS AND MAY RESULT IN SYSTEM DAMAGE , COMPONENT MALFUNCTION,
PROPERTY DAMAGE, AND PERSONAL INJURY.
IN063 Rev.E
Page 5 of 26
3 Saber Way, Ward Hill, MA 01835 | radonaway.com
Advertisement
Table of Contents
