Selecting Channels; Transmitting - GME CP30 Instruction Manual

5w uhf cb radio with programmable channels

Hide thumbs Also See for CP30:

Table of Contents

On/Off and Volume

Rotate the Volume Knob clockwise past the 'click' to switch the radio on.

Continue to rotate the Volume Knob clockwise to increase the volume.

Rotate the Volume Knob counter-clockwise to decrease the volume. Continue to

rotate the Volume Knob counter-clockwise past the 'click' to switch the radio off.

NOTE: If there are no signals available when adjusting the volume, set the

Volume knob to the 10 o'clock position. This should ensure sufficient volume to

hear incoming signals when they occur.

Selecting Channels

To select a channel, rotate the Channel Selector knob or press the

The selected channel will be shown on the display. If Channel Announce is On, the

channel number will be announced.

Before transmitting, check to see if the channel is already in use (the

will be visible). If the channel is busy, you should wait until it is clear before

transmitting.

NOTE: If the Busy Lockout feature is enabled in your radio's menu, your radio

will automatically prevent you from transmitting while the channel is busy.

To Transmit:

Press and hold the PTT (Push-to-Talk).

Hold the radio 3-5cm from your mouth and speak into the microphone

at a normal voice level. The microphone is quite sensitive so it is not

necessary to raise your voice or shout.

Release the PTT when you have finished talking.

When transmitting, the status LED lights Red and the

LCD.

CP30 INSTRUCTION MANUAL

keys.

icon

icon appears on the

Table of Contents