Avoid Scanning; Use Low Transmit Power; General Operation; Turning The Radio On/Off - GME TX667 Instruction Manual

AVOID SCANNING

The radio draws more power from the battery pack when scanning than when
monitoring a single channel. This is because it must 'wake up' more often to
monitor each channel for activity. In addition, scanning increases the chance of
finding a signal thereby keeping the receiver 'awake' and the squelch open more
often.

USE LOW TRANSMIT POWER

The transmitter has both high and low power settings. If you are only operating
over short distances, are in a reasonably high location or are close to a local
repeater, try using the Low transmitter power setting. This reduces the transmitter
power to 0.5 watts which increases the talk time available.

TURNING THE RADIO ON/OFF

To switch the radio on or off, hold the button for 2 seconds.

ADJUSTING THE VOLUME

 
Press the or
along with a value from 1 (min) to 9 (max).

SELECTING CHANNELS

1. Hold the Menu key for 2 seconds. The channel number will flash.
2. Press the
down one channel.
3. Press and hold the
through the channels.
To exit the channel mode:
Press the PTT switch or simply wait. The channel mode will automatically time
out after 10 seconds.repeater, try using the Low transmitter power setting. This
reduces the transmitter power to 0.5 watts which increases the talk time available.
TX667 Instruction Manual

GENERAL OPERATION

keys to increase or decrease the volume. 'VOL' is displayed

key to step up one channel. Press the
 
or keys to quickly scroll up or down

key to step
19