Main battery pack,
Blinking green and
Blinking orange slowly
Only for the main battery pack.
In high temperature mode, the 100% battery level is equivalent to 80% level of the normal temperature mode.
Once the battery is fully charged, the computer performs recharging only when the battery level becomes less than
approximately 95%, so overcharging is avoided.
When [LED] is set to [OFF] on the [Concealed Mode Configuration] menu, LED disappears (
Second battery pack
The battery pack is not inserted or not being charged.
Charging is in progress.
The battery is fully-charged.
In high temperature mode, the battery pack is discharging the power to 80%
temperature mode (
The remaining battery is approximately 9% or less.
The battery pack or the charging circuit is not operating properly.
The battery cannot be charged temporarily due to the following reasons:
• Its internal temperature is out of the acceptable range.
• The power supply is not enough because software applications or peripheral
devices are consuming a large amount of power.
The temperature is low and the computer is warming up to prevent the hard disk drive
from malfunctioning. The computer will start automatically after warming-up.
When you set [Battery Charging Indicator] to [Flashing] on the [Main Menu] of [Setup Utility].
21). Do not remove the battery pack in this status.