Panasonic Toughbook CF-29LCQGCBM Reference Manual page 14

Touch Pad
3
Select [No, not this time], then select [Next].
4
Select [Install from a list or specific location] and select [Next].
5
Select [Don't search. I will choose driver to install.], then select [Next].
6
Select [PS/2 Compatible Mouse], then select [Next].
7
At the confirmation message, select [Yes].
8
Select [Finish], then select [Close].
9
The display will ask you to restart Windows, select [Yes].
The computer will restart.
NOTE
If the additional functions of the external mouse or trackball cannot be used, even
after performing the operation above, perform the operation below.
A
Power off your computer (⇒ Operating Instructions "Starting Up/Shutting Down")
and connect the computer to the port replicator (⇒ Operating Instructions of the
Port Replicator).
B Connect the external mouse or trackball to the port replicator.
C Turn the computer on and run the Setup Utility (
D
In [Main] menu, set [Touch Pad] and [Touchscreen] (only for models with
touchscreen) to [Disable].
Close the Setup Utility by pressing F10. At the confirmation message, select [Yes].
E
F Log on to Windows with the administrator authority.
G If the message [Completing the Found New Hardware Wizard] is displayed, select
[Finish].
It may take a few minutes to complete this operation.
H
If the display asks you to restart Windows, select [Yes].
The computer will restart.
I Following the operating instructions of the connected external mouse or trackball,
install the necessary driver.
14
page 98).