Panasonic Toughbook CF-29LCQGCBM Reference Manual page 121

Dealing with Problems (Advanced)
Starting Up
When resuming from the standby or
hibernation mode, [Enter Password]
does not appear even if a password
has been set in the Setup Utility
When the administrator password is
forgotten
When "Remove disks or other media.
Press any key to restart" (or a similar
message) is displayed
[Executing Battery Recalibration]
screen is displayed
Even when a password has been set in the [Security] menu of the Setup Utility,
[Enter Password] does not appear when the computer resumes from the
standby or hibernation mode. If you want to use the security function when
using the standby or hibernation mode, use the Windows password as follows:
A
Select [start] - [Control Panel] - [User Accounts], and select the
account for which the password will be set.
B Select [Create a password], input the password, and then [Create
Password].
C
Add the check mark for [Prompt for password when computer
resumes from standby] in [Control Panel] - [Performance and
Maintenance] - [Power Options] - [Advanced].
If you have created a password reset disk (⇒ Operating Instructions "First-time
Operation"), a message is displayed when you fail to correctly enter the
password. Follow the message's instructions and set the password again by
using the password reset disk.
If you have not created a password reset disk, after reinstalling, setup Windows
and then set the password again.
This means a floppy disk that does not contain system startup information has
been left in the floppy disk drive. Remove the floppy disk, and press any key.
This message may appear when certain USB devices are connected. Remove
the USB device, or set [Legacy USB support] in [Advanced] menu of the Setup
Utility to [Disable].
If the message still appears even after trying the above measures, this may be
an indication that some type of hard disk failure has occurred. Contact
Panasonic Technical Support.
When Windows is shut down during the Battery Recalibration procedure, if you
select [Cancel] in the [End Program] screen, Windows shutdown is aborted. In
this case, Battery Recalibration will begin the next time the computer is started.
To start up Windows, turn off the computer by sliding the power switch, and
then turn it back on again.
121