Four-Faith YF360D Series User Manual page 28

Bridging-Create Bridge: creates a new empty network bridge for later use. STP means Spanning
Tree Protocol and with PRIO users are able to set the bridge priority order. The lowest number has
the highest priority.
Bridging - Assign to Bridge: allows users to assign any valid interface to a network bridge.
Consider setting the Wireless Interface options to Bridged if they want to assign any Wireless
Interface here. Any system specific bridge setting can be overridden here in this field.
Current Bridging Table: shows current bridging table
Create steps as below:
Click 'Add' to create a new bridge, configuration is as below:
Create bridge option: the first br0 means bridge name. STP means to on/off spanning tree
protocol. Prio means priority level of STP, the smaller the number, the higher the level. MTU
means maximum transfer unit, default is 1500, delete if it is not need. And then click 'Save' or
'Add'. Bride properties is as below:
Enter relewant bridge IP address and subnet mask, click 'Add' to create a bridge.
Note: Only create a bride can apply it.
Assign to Bridge option: to assign different ports to created bridge. For example: assign port
(wireless port) is ra0 in br1 bridge as below:
Prio means priority level: work if multiple ports are within the same bridge. The smaller the
number, the higher the level. Click 'Add' to take it effect.
Note: corresponding interface of WAN ports interface should not be binding, this bridge
function is basically used for LAN port, and should not be binding with WAN port
If bind success, bridge binding list in the list of current bridging table is as below:
Page 28 of 79
YF360D Series Router User Manual