Table of Contents
Advertisement
CAUTION!
Make sure you install the
anti-tilt protection at the
correct height.
Make sure that the surface behind the
appliance is smooth.
1. Set the correct height and area for
the appliance before you attach the
anti-tilt protection.
2. Install the anti-tilt protection 176 mm
down from the top surface of the
appliance and 24 mm from the left
side of the appliance into the circular
hole on the bracket. See the
illustration. Screw it into the solid
material or use applicable
reinforcement (wall).
3. You can find the hole on the left side
at the back of the appliance. See the
illustration. Put the appliance in the
middle of the space between the
cupboards (1). If the space between
the bench cupboards is larger than
the width of the appliance, you must
adjust the side measurement to
centre the appliance.
24 mm
1
3.5 Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
Applicable types of cables for
different phases:
Phase
1
3 with neutral
WARNING!
The power cable must not
touch the part of the
appliance shaded in the
illustration.
ENGLISH
9
Min. size cable
3x6.0 mm²
5x1.5 mm²
Advertisement
Table of Contents
