Handling Media - Epson SureColor F6470H User Manual

SC-F6400 Series/SC-F6400H Series
❏ Although the ink supply units may contain
recycled materials, this does not affect printer
function or performance.
❏ Do not dismantle or remodel ink supply units.
You may not be able to print properly.
❏ Do not drop or knock an ink supply unit against
hard objects; otherwise, the ink may leak from the
ink supply unit.
❏ Ink supply units installed in the printer must be
removed and thoroughly shaken once every week
for High Density Black, and once every three
weeks for other colors.
"Shaking" on page 59
U
❏ Due to the characteristics of the ink, the color of
the ink supply unit may change. This does not
affect the quality.

Handling Media

Note the following when handling or storing media.
Media that are in poor condition will not produce
good quality prints.
Be sure to read the documentation provided with each
type of media.
Notes on Handling
❏ Do not fold the media or damage the printable
surface.
❏ Do not touch the printable surface. Moisture and
oils from your hands can affect print quality.
❏ When handling media, hold it by both edges. We
recommend wearing cotton gloves.
❏ Keep the media dry.
❏ Packaging materials can be used to store media
and should not be thrown away.
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
User's Guide
Introduction
❏ When not in use, media should be removed from
Handling Media After Printing
To maintain long lasting, high quality print results,
note the following points.
❏ Do not rub or scratch the printed surface. If they
❏ Do not touch the printed surface, as this may
❏ Make sure printouts are completely dry before
❏ Avoid direct sunlight.
❏ To prevent discoloration, store prints as instructed
26
the printer, rewound, and inserted in its original
packaging for storage. Leaving media in the
printer for extended periods may cause it to
deteriorate.
are rubbed or scratched, the ink may peel off.
remove the ink.
folding or stacking, If the printouts are stacked or
taken up without being dried sufficiently, the
print surface may be damaged.
in the documentation supplied with the media.