Super Io Device - Acorp 4865PE Manual

Chapter 2

2.6.3 Super IO Device

Press <Enter> on the item "Super IO Device" to
configuree the Super IO devices. The following menu ap-
pears for user's configuration:
Phoenix - AwardBIOS CMOS Setup Utility
Onboard FDC Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x RxD, TxD Active
x IR Transaction Delay
x UR2 Duplex Mode
x Use IR Pins
Onboard Parallel Port
Parallel Port Mode
x EPP Mode Select
x ECP Mode Use DMA
PWRON After PWR-Fail
Game Port Address
MIDI Port Address
MIDI Port IRQ
←→↑↓: Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults
Onboard FDC Controller
The choices: Enabled (default) Disbled
Onboard Serial Port 1/2
Select an address and corresponding interrupt for the first and
second serial ports.
The Choices: Auto; 3F8/IRQ4; 2F8/IRQ3; 3E8/IRQ4; 2E8/
IRQ3; Disabled.
UART Mode Select
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Normal(default), IrDA, ASKIR.
UR2 Duplex Mode
This item allows you to select which Infra Red(IR) function of
the onboard I/O chip you wish to use.
The Choices: Half (default), Full.
OnChip IDE Device
Enabled
3F8/IRQ4
2F8/IRQ3
Normal
Hi, Lo
Enabled
Half
IR-Rx2Tx2
378/IRQ7
ECP
EPP1.7
3
Off
201
330
10
2-48
4865PE BIOS Setup
Item Help
F7:Optimized Defaults