Download Print this page

Kaiterra Sensedge Mini Installation Manual page 11

In-wall mount (drywall)

Hide thumbs Also See for Sensedge Mini:

B. Power the device via direct wiring

IMPORTANT SAFEGUARDS

Please use a power source within the range in the product speciﬁcation. Please contact the facility manager or

other responsible personnel if the power source speciﬁcation is not clear.

The device must be installed by certiﬁed electricians or other authorized personnel ONLY. When installing

the device, ALWAYS follow safety precautions to reduce risk of ﬁre, electric shock, injury to persons.

Make sure the power is cut off before proceeding!

Direct Wiring

To power your device via direct wiring, connect

your electrical wires from your low voltage trans-

former to a 4-pin Phoenix pin plug. Check the "+"

"-" marks on the back of the device to make sure

the wires are connected in the right order, and

fasten the screws on the Phoenix pin plug to

secure the wires.

Run the wires through the opening on the plate,

and plug the 4-pin Phoenix pin plug into the

corresponding terminals on the back of the device.

Table of Contents