DFI KM400A-MLV User Manual page 69

Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5
Disabled
Parallel Port Mode
The options are
standard specification and will depend on the type and speed of
your device. Refer to your peripheral's manual for the best op-
tion.
SPP
Allows normal speed operation but in one direction only.
ECP (Extended Capabilities Port)
Allows parallel port to operate in bidirectional mode and at a
speed faster than the normal mode's data transfer rate.
EPP (Enhanced Parallel Port)
Allows bidirectional parallel por t operation at maximum
speed.
If you selected EPP, the "EPP Mode Select" field is configurable. If
you selected ECP, the "ECP Mode Use DMA" field is configurable.
If you selected ECP+EPP, both "EPP Mode Select" and "ECP
Mode Use DMA" are configurable.
ECP Mode Use DMA
This is used to select the DMA channel of the parallel port.
3.1.4.4 Init Display First
This field is used to select whether to initialize the AGP or PCI
first when the system boots.
AGP
PCI Slot
IRQ for the onboard parallel port.
Disables the onboard parallel port.
SPP, EPP, ECP and ECP+EPP.
When the system boots, it will first initialize the
AGP.
When the system boots, it will first initialize PCI.
BIOS Setup
Selects the I/O address and
These apply to a
3
69