BRAYER BR1145 Instruction Manual page 6

6 EN
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after it was dropped, unplug the unit
and apply to the service center.
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL
OR LABORATORY PURPOSES
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit or
correspond to the specifications of your mains. When
the unit is used in the mains with 60 Hz frequency, it
does not need any additional settings.
• Wipe the outer surface of the unit body (1) with a
clean, slightly damp cloth to remove dust.
• Place the body (1) on a solid steady flat and non-slip
non-metal surface away from heat sources as far as
possible from the edge of the surface.
• Do not place and do not use the coffee maker in
closed space, for example, in the cupboard or in
closed structures — this can lead to its breakage,
cause harm to the user or damage to his/her
property.
• Grasp the handle (5), slightly lift and remove the flask
(2) from the coffee maker body (1).
• Wash the inner surface of the flask (2) using neutral
detergents, rinse and dry, do not let the detergent
come into contact with the flask contact group (2).
. Wipe the outer surface of the unit body (1) with a
slightly damp cloth and then wipe it dry. Do not use
abrasives or coarse scourers for this.
• Before connecting the coffee maker, make sure that
there are no moisture drops on the unit body (1), the
power cord and the power plug.
• Fill the flask with water up to the maximal level mark.
• Set the coffee maker filled with water.
• Insert the power plug into the mains socket.
• Set the power switch press the « » button (3), you
will hear a sound signal and the backlight of the « »
button (3) will turn red.