Advertisement
Programming
Tea Dilution Stir (Factory set to ON).
Tea Dilut Stir
Press
Tea Pulse Brew (Factory set to OFF).
Press
Tea Pulse Brew
from 5 to 150 seconds and an OFF time from 5 to 150 seconds.
Tea Fast Brew (Factory set to OFF).
Tea Fast Brew
Press
Tea Half Batch (Factory set to OFF).
Tea Half Batch
Press
Tea Drip-Out (Factory set to OFF)
Tea Drip-Out
Press
Temperature (Factory set to 204ºF)
Press
Temperature
increments.
Energy Save Mode (Factory set to OFF)
Press
last brew. When feature is OFF, unit does not have the energy saving mode.
In the ON 140ºF position, temperature goes down to 140ºF. if unit has not brewed in 4 hours. This feature will save
energy by maintaining a lower temperature in the tank during periods of non-operation.
Brew Count Odom.
Press
Brew Count Odom
Brew Count Total
Brew Count Total
Press
Cold Brew Lock (Factory set to 5º F)
Press
Cold Brew Lock
The Cold Brew Lock feature allows the brewer to brew at three different temperature levels from the actual set point.
set point for the Ready to Brew message, however it will brew at any temperature.
Master Reset
Press
tions in the UCM return to factory defaults.
Service Call (Phone number Factory set to 1-800-000-0000)
Service Call
Press
be displayed during a Heating system SENSOR ERROR or during a WATER ERROR.
Access Code (Factory set to 1-2-3-4)
Access Code
Press
when complete.
to Select. Press < or > buttons, to toggle between OFF and ON. Press
to Select. Press < or > to select ON, OFF or D. D is a manual adjust from 1 to 20 pulses with an ON time
to Select. Press < or > buttons, to toggle between OFF and ON. Press
to Select. Press < or > to adjust time. Settings are OFF, up to 15 minutes, at one minute increments.
to Select. Press < or > to increase or decrease setting. Temperature range, from 170ºF to 208ºF in 2-degree
to Select, < or > ON, OFF or ON 140ºF ,
to Select, Shows total gallons and total brew cycles on the unit. Press ex or Reset Brew Count Total.
to Select, Shows total gallons and total brew cycles on the unit. Cannot be reset.
to select, < or > to select desired setting (CBL 5, 15 or OFF),
to display Are You Sure? Then < for Yes, > for No. When Master Reset is used, the all of the menu selec-
to display number and change number or < to move place and EX to exit when complete. This number will
to display number and change number, (the number can be changed 1 to 4) or < to move place and ex to exit
to set.
to set.
to set. When in ON, unit will automatically shut off 4 hours from
to set.
Continued on Page 4
3
Advertisement
