Table of Contents
Advertisement
CAUTION! Never cover the air vents. They must always be open for proper motor cooling. Make sure that
the work piece is free of nails and other foreign objects that could tear the abrasive belt.
OPERATING THE BELT SANDER
1. Hold machine firmly with both hands, one hand on the front handle and
one hand on the back handle, and assume a balanced position.
2. Pull the trigger switch (Fig. 4 - 1) and allow the motor to reach full
speed. For continuous operation, press in the power lock-on button (Fig.
4 - 2) located on the side of the handle.
3. Hold the machine parallel to the work piece. Gently bring belt into con-
tact with the surface.
CAUTION! The sander may initially lunge forward. Resist the for-
ward motion and keep the belt sander moving at an even pace.
Never exert excessive pressure on the tool. The weight of the tool applies adequate pressure. Excessive pressure
prevents proper sanding, leaving an uneven finish and excess wear to both the tool and the abrasive belt.
4. Adjust the belt's speed using the speed dial near the trigger (Fig. 4 - 3).
5. Once finishing your sanding operation, lift the belt sander off the work piece before turning off the switch. Wait
until the belt has stopped rotating before setting down the tool on its side.
CAUTION! If the sander makes an unfamiliar sound or vibrates excessively switch it off immediately and
disconnect from the power supply. Investigate the cause or consult a service center for advice.
OPTIMIZING BATTERY RUNTIME
1. The runtime of your battery is highly dependent upon the speed at which you are sanding. To optimize the battery
runtime of your sander, operate at the lowest speed setting that is suitable for your application.
WARNING! To avoid accidents, make sure the power switch is in the OFF position and remove the battery
from the tool before cleaning or performing any maintenance. Servicing of the tool must be performed by a
qualified technician.
SERVICE
Preventive maintenance performed by unauthorized personnel may result in misplacing of internal wires and com-
ponents, possibly causing a serious hazard. Call WEN customer service line at 1-800-232-1195 for product support.
CLEANING
Ventilation openings and switch levers must be kept clean and free of foreign matter. The tool may be cleaned most
effectively with compressed dry air. Do not attempt to clean these components by inserting pointed objects through
openings. Certain cleaning agents and solvents damage plastic parts; this includes but is not limited to gasoline,
carbon tetrachloride, chlorinated cleaning solvents, ammonia and household detergents that contain ammonia.
16
OPERATION
MAINTENANCE
Fig. 4
3
2
1
Advertisement
Table of Contents
