Default Settings Of [User1] - [User3] - Panasonic PT-F100NTE Network Manual

Network setting of the projector
Additionally perform the following setting using the [AUTHENTICATION] setting.
WIRELESS DETAILED SETUP
USER1
DEFAULT KEY
KEY1
KEY2
KEY3
RETURN
KEY4
SELECT
RETURN
When setting [OPEN] or [SHARED] as authentication and setting [WEP
DEFAULT KEY : Set 1 – 4 numerals for the default key.
KEY 1 – 4 : Set these to match the WEP key registered in [DEFAULT KEY].
Either the 64-bit or 128-bit WEP key can be set. For the 64-bit key, input five alphanumerics (or a 10-digit
string for the hexadecimal format) for the 128-bit key, input 13 alphanumerics (or a 26-digit string for the
hexadecimal format).
When setting [WPA-PSK
Input either 8 to 63 alphanumerics or a 64 digit string in the hexadecimal format.
※ "Glossary" (See page 71)
Important video/audio data is protected because AES
even if [ENCRYPTION] is set to [NONE].
※ "Glossary" (See page 71)

Default settings of [USER1] - [USER3]

The following settings as [USER1] - [USER3] in the wireless LAN are set before the projector leaves the factory.
SSID : Panasonic Projector
DHCP : OFF
IP ADDRESS : 192.168.11.100
SUBNETMASK : 255.255.255.0
GATEWAY : 192.168.11.1
MODE : AD HOC
AUTHENTICATION : OPEN
ENCRYPTION : NONE
3/3
1
＊ ＊ ＊ ＊ ＊ ＊ ＊ ＊
＊ ＊ ＊ ＊ ＊ ＊ ＊ ＊
＊ ＊ ＊ ＊ ＊ ＊ ＊ ＊
＊ ＊ ＊ ＊ ＊ ＊ ＊ ＊
OK CANCEL
※ ] as authentication : Set key and select [OK].
※
(cont.)
] as the encryption method:
※
encryption processing takes place in advance for all network numbers,
56