Baumatic BW300SS Instruction Manual page 21

9) Place the upper door pin (4) into the hole on the left hand side
of the wine cooler door (8). Tighten the upper door pin fully,
using a flat head screwdriver (S2).
10) Fix the upper left hand hinge (2) to the opposite side of the
cabinet using the hinge screws (1), ensuring that the screws are
fully tightened.
IMPORTANT: Check that the door opens and shuts correctly,
without fouling, after you have completed the door reversal
process.
After the door has been reversed, you should check
the door seal of the wine cooler. The seal should not
be creased or crushed; otherwise there will be a gap
between it and the inside of the door.
o The seal must adhere properly all the way around the door.
o If the seal is not adhering to the cabinet properly, then you
should either:-
a) Use a warm damp cloth and manipulate the seal until it does
adhere to the cabinet properly, all the way around the door.
or
b) Use a hair dryer on its lowest heat setting and lightly heat the
areas of the door seal that are not adhering correctly. The heat
will make the seal more pliable and this will allow you to
manipulate the seal into the correct position.
IMPORTANT: DO NOT HEAT THE DOOR SEAL ON ANYTHING BUT
THE LOWEST HEAT SETTING, OR HEAT THE SEAL FOR A LONG
PERIOD OF TIME. OTHERWISE DAMAGE MAY BE CAUSED TO
THE DOOR SEAL, WHICH WOULD NOT BE RECTIFIED UNDER
THE GUARANTEE FREE OF CHARGE.
21