Using The Remote 2 Terminal - Panasonic DLP PT-D3500U Operating Instructions Manual

Using the REMOTE 2 terminal

Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Example of a control panel layout
Projector set up in a meeting room
Pin assignments and control
Be sure to short-circuit Pins
D-Sub 9-pin (female)
external appearance
• The following buttons on the remote control and the operation area of the projector can no longer
Note
be operated when pins
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
• If you short pin
following buttons on the projector operating area and the remote control can no longer be
operated: POWER button, RGB button (RGB1, RGB2 and DVI buttons in case of remote control),
VIDEO button (VIDEO and S-VIDEO buttons in case of remote control) and SHUTTER button.
Neither will it be possible to use the RS232C commands or network functions corresponding to
these functions.
and when controlling.
and are shorted: POWER button and SHUTTER button.
and pin , and also short one of the pins from
Remote terminal
Remote terminal/External control
STANDBY
LAMP
RGB1
RGB2
DVI
Control panel located in a different room
Open (H)
Names of terminals
GND
POWER OFF
RGB1 Other
RGB2 Other
VIDEO Other
S-VIDEO Other
DVI Other
SHUTTER OFF
RST / SET
Controlled by remote control
to
External control
ON
VIDEO
S-VIDEO
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI
ON
Controlled by external contact
and pin , then the
41