Sharpness; Tv-System; System - Panasonic DLP PT-D3500U Operating Instructions Manual

Adjusting the picture

SHARPNESS

"SHARPNESS" is used to adjust the crispness of
the image.
: Sharpens the edge of the image.
: Softens the edge of the image.
NR
In this mode, the video noise is reduced.
(For S-Video/Video/YP
OFF : No correction
ON : Noise reduction is set to ON.
(For RGB/DVI signals)
OFF : No correction
1 : Low
2 : Middle
3 : High
AI
Gray scale control is exercised to suit the images,
and optimal images with a clear contrast are
projected.
ON : Standard setting
OFF : The AI mode is set to OFF.

TV-SYSTEM

(For S-Video/Video signals)
The setting that corresponds to the TV system is
selected here.
AUTO1 : Standard setting
Automatically selects the TV standard
that matches the input video signal, out
of NTSC, PAL, NTSC4.43, SECAM and
PAL60.
AUTO2 : Automatically selects the TV standard
that matches the input video signal, out
of NTSC, PAL-M, and PAL-N.
• Normally "AUTO1" or "AUTO2" should be
chosen for this option.
• If the video signals are not displayed properly
due to signal deterioration, choose the TV
system that matches the input video signals.
Automatically selected by detecting the
horizontal/vertical scan frequencies and color sub-
carrier listed in the table below:
H. Scan
Signal
Frequency

System

(kHz)
NTSC 15.75
NTSC4.43 15.75
PAL 15.63
PAL-M 15.75
PAL-N 15.63
SECAM 15.63
PLA60 15.75
30
P signals)
B R
V. Scan Color
Frequency Subcarrier
(Hz) (MHz)
60.00 3.58
60.00
4.43
50.00
60.00
3.58
50.00
50.00 4.25 or 4.41
60.00 4.43
SYSTEM
(For RGB/YP
This enables the RGB system or YP
be selected.
For the signals which are supported, refer to page
60.
P signals)
B R
P system to
B R