How To Use Advanced Menu; Digital Cinema Reality; Blanking; Input Resolution - Panasonic DLP PT-D3500U Operating Instructions Manual

How to use ADVANCED MENU

ADVANCED MENU

DIGITAL CINEMA REALITY

BLANKING

INPUT RESOLUTION

CLAMP POS.

RASTER POSITION

SXGA MODE

SELSCT ENTER
DIGITAL CINEMA REALITY
(Only for input of S-Video/ Video/ YP
576i] signals.)
ON: Set at ON when you need to faithfully
capture images shot at 24 frames per
second as in movies.
OFF: Set at OFF when unnatural images are
obtained in the ON status.
BLANKING
You can perform fine adjustments for blanking if
noise appears at the ends of the screen or the
image protrudes out of the screen during image
projection using a video deck and so on.
: Select the UPPER, LOWER, LEFT or
RIGHT adjustment.
: Adjust the blanking width.
For upper adjustment
For left adjustment
32
1
SXGA
RETRN
P [480i,
B R
For lower adjustment
For right adjustment
INPUT RESOLUTION
Input resolution adjustment achieves the best
image when the screen flickers or halo is observed
around the contour.
: These select the items listed below.
: These select the value.
"TOTAL DOTS", "DISPLAY DOTS", "TOTAL
LINES" and "DISPLAY LINES"
Each item automatically displays a value in response
to the type of the input signal. If vertical stripes
appear on the screen or the image is partly missing,
increase or decrease the displayed value while
observing the screen to achieve the optimal value.
• The abovementioned vertical stripes
Note
will not appear on the screen when all
signals are input.
• The picture may be distorted during the
adjusting operation, but this is not a fault.
• The input resolution can be adjusted
only when RGB signal input is applied
with RGB1 and RGB2 IN.
CLAMP POS.
(For RGB/ YP P signals only)
B R
Use the clamp position adjustment to achieve the
optimal value when dark areas of the image are
crushed or displayed in green.
Adjust with the
The value changes from 1 to 255.
The optimal value for the clamp position adjustment
• If dark areas are crushed:
The optimal value is the point where the dark
area is best improved.
• If the dark areas are displayed in green:
The optimal value is the point where the
green area becomes dark and clear.
• The clamp position can be adjusted
Note
only when the RGB signal input is
applied with RGB1 and RGB2 IN.
RASTER POSITION
When the whole area where the input picture can
be displayed is not used, the picture can be moved
to any position inside the display area.
: These adjust the value in the horizontal
direction.
: These adjust the value in the vertical
direction.
SXGA MODE
This mode takes effect only when SXGA (RGB)
signals are input.
SXGA : Standard setting
SXGA+: Select this when the screen is cut off.
buttons.