Table of Contents
Advertisement
7. M: Wireless Flash Shooting with Manual Flash
This describes wireless (multiple shooting) using manual flash. You
can shoot with a different flash output setting for each slave unit
(firing group). Set all parameters on the master unit.
MODE
ZOOM
SYNC
SLAVE
SET
MODE
ZOOM
SYNC
SLAVE
SET
8. Multi: Wireless Flash Shooting with Manual
Flash
MODE
ZOOM
SYNC
SLAVE
SET
Using a flash (master/slave) with a radio transmission wireless
shooting function make it easy to shoot with advanced wireless
multiple flash lighting, in the same way as TTL autoflash shooting.
The basic relative position and operation range are as shown in the
picture. You can then perform wireless TTL autoflash shooting just
by setting the master unit to <TTL>.
- 39 -
1
Setting the flash mode to
<M>
● Press the <MODE> Button
to set the flash to M mode.
2
Setting flash output
● Turn the Select Dial to set
the flash output of the
groups.
3
Taking the picture
● Each group fires at the set
flash ratio.
1
Setting <Multi>
stroboscopic flash.
● Long press the <MODE>
button for 2 seconds so that
<Multi> is displayed. Long
press the <MODE> button
for 2 seconds again to exit.
2
Setting flash output/flash
frequency/flash times.
● Setting the flash
output/flash frequency/flash
times in the A group. Setting
the multi flash mode. (see
Page35 )
● B and C group can only
control the ON/OFF of the
slave unit by pressing the
<MODE> Button.
Slave/Master Unit's Positioning and Operation Range
● Autoflash Shooting with One Slave Unit
● Use the supplied mini stand to position the slave unit.
● Before shooting, perform a test flash and test shooting.
● The transmission distance might be shorter depending on the
conditions such as positioning of slave units, the surrounding
environment and whether conditions.
Wireless Multiple Flash Shooting
You can divide the slave units into two or three groups and perform
TTL autoflash while changing the flash ratio (factor). In addition, you
can set and shoot with a different flash mode for each firing group,
for up to 3 groups.
● Auto Shooting with Two Slave Groups
● Auto Shooting with Three Slave Groups
The Reason & Solution of Not Triggering in Godox 2.4G Wireless
1. Disturbed by the 2.4G signal in outer environment (e.g. wireless base
station, 2.4G wifi router, Bluetooth, etc.)
→ To adjust the channel CH setting on the flash trigger (add 10+ channels) and
use the channel which is not disturbed. Or turn off the other 2.4G equipment
in working.
2. Please make sure that whether the flash has finished its recycle or caught up
with the continuous shooting speed or not(the flash ready indicator is lighten)
and the flash is not under the state of over-heat protection or other abnormal
situation.
→Please downgrade the flash power output. If the flash is in TTL mode, please
try to change it to M mode(a preflash is needed in TTL mode).
Transmission distance is about 30m.
A
B
C
A
B
- 40 -
Advertisement
Table of Contents
