Setting The Communication Channel; Wireless Id Settings; Ttl: Fully Automatic Wireless Flash Shooting - Godox TT350C Instruction Manual

Slave Unit Setting
ZOOM SYNC SLAVE
SET
2. Setting Group Unit's Flash Mode
ZOOM SYNC SLAVE
SET
MODE ZOOM SYNC SLAVE
SET
3. Master Unit's Flash OFF

4. Wireless ID Settings

Change the wireless channels and wireless ID to avoid interference for it
can only be triggered after the wireless IDs and channels of the master
unit and the slave unit are set to the same.
Press the <MENU> button to enter C.Fn ID. Press the <SET> button to
choose OFF channel expansion shutdown, and choose any figure from 01
to 99.

5. Setting the Communication Channel

If there are other wireless flash systems nearby, you can change the
channel IDs to prevent signal interference. The channel IDs of the
master unit and the slave unit(s) must be set to the same.
ZOOM SYNC SLAVE
SET
- 37 -
1
Long Press the <SYNC>
button for 2 seconds so that
< > is blinking. Turn the
Select Dial until the < > is
displayed on the LCD panel,
which means the slave unit.
1
Press the <SLAVE> Button to
choose the group from A/B/C.
Then, press the < MODE >
Button so that the master unit
can work in OFF / TTL / M
flash mode. Choose one of
them as the flash mode of
master unit.
2
Press the <MODE> Button for
2 seconds to switch to Multi
mode.
1
When the flash attach to
camera, enter the external
speedlite control on the camera
menu.
2
Turn off the master control
f l a s h o n t h e c a m e r a .
The < > icon will blink on the
TT350C panel, and the flash
master control unit is disabled.
Select turn on to cancel the
master control unit disabled.
1
Long press the <SLAVE>
Button for 2 seconds until the
channel IDs is blinking. Turn
the Select Dial to choose a
channel ID from 1 to 16.
2
ZOOM SYNC SLAVE
SET

6. TTL: Fully Automatic Wireless Flash Shooting

Autoflash Shooting with One Slave Unit
1
MODE ZOOM SYNC SLAVE
SET
The slave unit might be out of order or fire an unwanted flash
due to the nearby wifi routers or other 2.4G equipments. If in
this case, please adjust the flash's channel or turn off the 2.4G
equipments.
Press the <SET> button to
confirm.
Master Unit Setting
● Attach a TT350C camera
flash on the camera and set it
as the master unit. (Page 36)
● A/B/C can be set as
TTL mode independently.
2
Slave Unit Setting
● Set the TT350C that to be
controlled as the wireless
slave unit. (Page 37)
● The slave unit can be set
as A/B/C.
3
Check the communication
channel
● If the master unit and
slave unit(s) are set to a
different channel, set them
to the same channel.
(Page 37)
4
Position the camera and
flashes
● Position the camera and
flashes as the picture
shows. (Page 40)
5
Check the flash operation
● Press the master unit's
Test Button< >.
● Then, the slave unit will
fire. If not, adjust the slave
unit's angle toward the
master unit and distance
from the master unit.
- 38 -