Comfort Setting - Hitachi airPoint Room 700 Operation Manual

5.8 Comfort Setting

This function is used to control discharge or supply air temperature when in the cooling mode.
NOTES:
•
This function cannot be set when the indoor unit does not support this function.
•
The cool air level order is as follows: "High" > "Med" > "Low" and the temperature of the discharged air is
high.
•
The effect may not be sufficient if two or more units are operating in the room, which the air may be "cold".
•
When this function is set, it may take time for the entire room to cool down.
1. Set the comfort
Step1. Select "Comfort Setting" on the "Function Menu" screen
and press "OK".
Step2. Press " " or " " to select "GentleCool Comfort", and then
press "OK".
•
For other settings, please refer to the Operation Manual
of the indoor unit.
Step3. Press " " or " ", the selected comfort level changes as
follows:
"Not Set" ↔ "Low" ↔ "Med" ↔ "High".
Select the "GentleCool Comfort" during cooling and press
"OK".
Press " " to return to the "Function Menu" screen.
A16381TMEU
5. Function Menu Screen Display
Function Menu
Power Consumption Display
Autoboost
Comfort Setting
Motion Sensor Setting
Setback Setting
OK Select
Comfort Setting
GentleCool Comfort
Louver Direction in Cooling Mode
Louver Direction in Heating Mode
Radiant Sensor Control for Heating
FeetWarm Heat Air Flow
Select
OK
GentleCool Comfort
Not Set
Low
Med
High
Select
OK
(Mon) 16:30
Back
Back
Back
29