Gigabyte MS73-HB2 User Manual page 76

Parameter
SATA And RST
Configuration/
SATA Controller And RST
Configuration (continued)
SATA And RST
Configuration/
sSATA Controller And RST
Configuration
Only appears when HDD sets to RAID Mode.
(Note)
Description
Port 0/1/2/3/4/5/6/7
Š
– Enable/Disable Port 0/1/2/3/4/5/6/7 device.
– Options available: Enabled, Disabled. Default setting is Enabled.
Hot Plug (for Port 0/1/2/3/4/5/6/7)
Š
– Enable/Disable HDD Hot-Plug function.
– Options available: Enabled, Disabled. Default setting is Enabled.
Spin Up Device (for Port 0/1/2/3/4/5/6/7)
Š
– On an edge detect from 0 to 1, the PCH starts a COM reset
initialization to the device.
– Options available: Enabled, Disabled. Default setting is Disabled.
SATA Configuration
Š
– Enable/Disable SATA controller.
– Options available: Enabled, Disabled. Default setting is Enabled.
SATA Mode Selection
Š
– Configures on chip SATA type.
– AHCI Mode: When set to AHCI, the SATA controller enables its AHCI
functionality. Then the RAID function is disabled and cannot be access
the RAID setup utility at boot time.
– RAID Mode: When set to RAID, the SATA controller enables both its
RAID and AHCI functions. You will be allowed to access the RAID
setup utility at boot time.
– Options available: AHCI, RAID. Default setting is AHCI.
Alternate Device ID on RAID
Š
– Enable/Disable Alternate Device ID on RAID mode.
– Options available: Enabled, Disabled. Default setting is Disabled.
SATA Port 0/2/4/5/6/7
Š
– The category identifies sSATA hard drives that are installed in the
computer. System will automatically detect HDD type.
SATA Port 0/2/4/5/6/7
Š
– Enable/Disable Port 0/2/4/5/6/7 device.
– Options available: Enabled, Disabled. Default setting is Enabled.
Hot Plug (for Port 0/2/4/5/6/7)
Š
– Enable/Disable HDD Hot-Plug function.
– Options available: Enabled, Disabled. Default setting is Enabled.
Spin Up Device (for Port 0/2/4/5/6/7)
Š
– On an edge detect from 0 to 1, the PCH starts a COM reset
initialization to the device.
– Options available: Enabled, Disabled. Default setting is Disabled.
BIOS Setup
- 76 -
(Note)