Table of Contents
Advertisement
LAN and ID Button LEDs
Speed LED
Link/Activity LED
LAN Port
• When removing the cable connected to a back panel connector, first remove the cable from your
device and then remove it from the motherboard.
• When removing the cable, pull it straight out from the connector. Do not rock it side to side to
prevent an electrical short inside the cable connector.
10GbE LAN LED:
State
Description
Yellow On
5Gbps, 2.5Gbps, 1Gps data rate
Green On
10Gbps data rate
Off
100Mbps data rate
ID button/LED:
State
Description
Blue On System identification is active
Off
System identification is disabled
Hardware Installation
- 18 -
10/100/1000 LAN LED:
State
Description
Yellow On
1Gbps data rate
Green On
100Mbps data rate
Off
10Mbps data rate
Advertisement
Table of Contents
