Table of Contents
Advertisement
Parameter
iSCSI General Parameters
(continued)
iSCSI Initiator Parameters
iSCSI First/Second Target
Parameters
Description
Use TCP Timestamp
Š
– Enable/Disable the TCP timestamp.
– Options available: Enabled, Disabled. Default setting is Disabled.
Target as First HDD
Š
– Enable/Disable target appears as first hard disk drive (HDD) in the
system.
– Options available: Enabled, Disabled. Default setting is Disabled.
LUN Busy Retry Count
Š
– Configures the number of retries in 2 second intervals when LUN is
busy (0-60).
– Default setting is 0.
IP Version
Š
– Displays the IP version supported. Modifying this parameter will reset
all IP-related fields.
– Options available: IPv4, IPv6. Disabled. Default setting is IPv4.
Press [Enter] to configure advanced items.
IP Address
Š
– Configures the initiator IP address.
Subnet Mask
Š
– Configures the IP subnet mask.
Default Gateway
Š
– Configures the default gateway IP address.
Primary DNS
Š
– Configures the primary DNS IP address.
Secondary DNS
Š
– Configures the secondary DNS IP address.
iSCSI Name
Š
– Configures the iSCSI name.
CHAP ID
Š
– Configures the Challenge-Handshake Authentication Protocol
(CHAP) ID (up to 128 characters in length).
CHAP Secret
Š
– Configure the Challenge-Handshake Authentication Protocol
(CHAP) Secret (12 to 16 characters in length).
Press [Enter] to configure advanced items.
Connect
Š
– Enable/Disable the target establishment.
– Options available: Enabled, Disabled. Default setting is Disabled.
IP Address
Š
– Configures the Target IP address.
TCP Port
Š
– Configures the Target TCP port number (1-65535).
BIOS Setup
- 54 -
Advertisement
Table of Contents
