Scan Voice - AOR The Superior AR820 0 Series Operating Manual

Use the keys to select the SCAN-GROUP number between 1 and 9.
display the scan environment parameter of LEVEL.
as a short cut to off (which is the default). Use the main dial to increment value by
1 or use the keys to increment by 10.
While adjusting level squelch, the "
indicating that the current value will not cause the squelch to close. Increase the value until the "
legend is just extinguished (this may typically be around a value of 120 - 230), the current transmission
and signals below this level will be skipped. There will be no audio produced when a transmission is
encountered below the level configured even though the "S" squelch legend is displayed. This is a
useful alternative to regular squelch on noisy bands such as short wave.
The approximate relationship between signal meter segments and level value is as follows:
1 2
124 141 154
Note: When level squelch is in operation, the rotary squelch control is usually best
rotated to the fully anti-clockwise position.
to accept the changes and return to the display prior to accessing the scan
environment menu. Alternatively you may move to the next option (scan VOICE squelch) by pressing the
key.
While scanning, the LCD legend "LSQ" is displayed to indicate that scan LEVEL squelch is in operation.

7-8-3 Scan VOICE

The scan VOICE squelch parameter causes the AR8200 to check the current frequency for valid audio
and to only open the squelch when audio above a specified level (which is programmable in 256 steps) is
detected. The limits are OFF and 1 to 255 (default off).
Scan VOICE is configured via the SCAN-GROUP menu. Use the key sequence
to access the "SCAN-GROUP" menu. Use the
number between 1 and 9.
as a short cut to off (which is the default). Use the main dial to increment value by
1 or use the keys to increment by 10.
While adjusting voice squelch, the "
indicating that the current value will not cause the squelch to close. Increase the value until the "
legend is just extinguished (this may typically be around a value of 1 to 100), the current transmission
and signals with audio below this level will be skipped. There will be no audio produced when a
transmission is encountered with audio below the level configured even though the "S" squelch legend is
displayed.
" legend will be displayed to the left of the value "LEVEL
3 4 5 6
168 178 185
five times to display the scan environment parameter of VOICE.
" legend will be displayed to the left of the value "VOICE
7 8 9 10
193 200 203 206
Section 7-8-2, 7-8-3
four times to
11 12 13
208 210 212 214
keys to select the SCAN-GROUP
3"
"
14
12"
"
69