Table of Contents
Advertisement
No.
U036
Feed timing is selected.
When stitches are not well-tightened, set the value in
"–" direction.
U037
State of work clamp foot after completion of sewing can be selected.
: Work clamp foot goes up after moving at the sewing start
: Work clamp foot goes up immediately after the end of sewing.
: Work clamp foot goes up by pedal operation after moving
at the sewing start.
Execution of origin retrieval every time after completion of
U039
sewing can be performed.
(Except cycle stitching)
: Without origin retrieval
U040
Setting of origin retrieval in cycle stitching can be set.
: Without origin retrieval
: Every time 1 pattern is completed
: Every time 1 cycle is completed
U041
State of work clamp foot when machine stopped by temporary
stop command can be selected.
: Work clamp foot goes up.
: Work clamp foot goes up with work clamp foot switch.
: Lift of work clamp foot is prohibited.
Needle bar stop position is set.
U042
: UP position
Thread trimming can be prohibited.
U046
: Normal
U048
Route of origin return by means of clear key can be selected.
: Straight line return
U049
Bobbin winding speed can be set.
U051
Wiper operation method can be selected.
: Without wiper at the time of thread trimming on the way
: With wiper at the time of thread trimming on the way ①
: With wiper at the time of thread trimming on the way
Function
: With origin retrieval
: Upper dead point
: Thread trimming prohibited
: Reverse return of pattern
－
Setting range State when delivered
− 8 to 16
-
-
-
-
-
-
-
800 to 2000
-
－
61
Remarks
12
Setting on exces-
sive "–" side may
cause needle break-
a g e . B e c a r e f u l
when sewing heavy-
weight material.
For LK-1903S/
BR35, set to "
Needle bar rotates
in the reverse direc-
tion after the UP po-
sition stop and stops
when upper dead
point stop is set.
T h i s f u n c t i o n i s
used when straight
line return from the
midway of pattern
to the start of sew-
ing is not possible.
1600
Max. speed limita-
tion has priority.
① : Without return
of the last wiper
② : With return of
the last wiper
".
Advertisement
Table of Contents
