Table of Contents
Advertisement
Hardware References
Connectors
J1:A
LEDs
LED1:A
LED2:A/LED3:A
D1
D2
D3
Resistors and Capacitors
R18-R33
C24-C39
R11 and C13
10
TMDSCNCD2800137 controlCARD Information Guide
Figure 6-2. Key Components on the controlCARD - Back
Table 6-1. Hardware Connections
Emulation/UART connector/Power - USB-C connector used to provide XDS110 emulation and USB-to-
UART (SCI) communication through MSP432 logic. S1:A determines which connections are enabled to
the MCU.
The USB-C connector also provides power on the controlCARD.
Turns on (red) when 5 V is supplied to the controlCARD
(5 V can be supplied either through the USB-C connector or externally through the HSEC connector)
JTAG/UART RX/TX toggle indicator (blue)
Controlled by GPIO–24 with negative logic (red)
Controlled by GPIO–39 with negative logic (red)
Turns on (green) when 3.3 V is supplied to the controlCARD from the on-board LDO (U3)
ADC RC input filter resistors: Series resistors which can be used to create an RC filter on the ADC's
input.
ADC RC input filter capacitors: Optional capacitors, not populated by default, for the ADC input's RC
filters.
External precision resistor. Optional external precision resistor (ExtR), no populated by default, to
achieve better accuracy with INTOSC2. Refer to the F280013x data sheet for more information on the
ExtR feature.
Copyright © 2022 Texas Instruments Incorporated
SPRUJ15B – NOVEMBER 2021 – REVISED OCTOBER 2022
Submit Document Feedback
www.ti.com
Advertisement
Table of Contents
