Monte Carlo Fan Company 3CNHSM52 Series Owner's Manual And Installation Manual page 5

13
Housing
Attach housing onto mounting plate,
aligning the keyhole slots on the housing
with the screws on mounting plate and
twist clockwise till tight. Reinstall the
screw removed in step 12. Tighten all
screws securely.
15
Blade
Align the 2 side holes on the blade with
the screw holes on the motor. Install the
blade by setting screws with washer
provided. Repeat this process for other
blades. Tighten all screws securely.
The middle hole is for blade supporting
plate installation on next step.
© 2022 Monte Carlo Fan Collections
14
Decorative ring
Attach decorative ring by locating the head of set screws on housing with grooves in
the decorative ring and twist clockwise till tight.
Place the wi-fi antenna outside the housing and stick/fix it onto ceiling.
16
THIS SIDE UP
Blade supporting
plate
Align the holes on the blade supporting
plate with the middle hole of the blades
and install set screws provided. Tighten
set screws securely.
Note: Make sure the side with a mark
"This side up" is installed upward.
5
Note : For better performance of the remote
operation, keep the WIFI antenna apart from
the antenna of the receiver.
Wi-Fi antenna
Antenna of receiver
Fan housing
8/2022