Monte Carlo Fan Company 3CNHSM52 Series Owner's Manual And Installation Manual page 4

7
Black
Power source
Ground/
White
Green
White
Black
Make wiring connections using wire connectors provided as indicated above.
Brown wire from fan to Brown wire from receiver marked Motor U.
Gray wire from fan to Gray wire from receiver marked Motor V.
Blue wire from fan to Blue wire from receiver marked Motor W.
White (Neutral) wire from house to White wire from remote marked AC IN N.
Black (Live) wire from house to Black wire from remote marked AC IN L.
Connect all green grounded wires to Grounded wire from House.
Make sure that no filaments are outside of the wire connectors.
Attach the remote receiver onto the bracket on the motor by preadhered double-sided foam tap on the receiver.
After making the wire connections, the wires should be spread apart with the grounded conductor and the equipment-grounding conductor on one
side of the outlet box and ungrounded conductor on the other side of the outlet box. The splices after being made should be turned upward and
pushed carefully up into the outlet box.
Caution: The installation has to be complete before operate the fan. Receiver has to be used on the fan and cannot be bypassed.
10
Lift motor assembly, aligning the holes on
the plate on top of motor with the screw
holes on mounting plate. Install set
screws to fix them. Screws provided.
Tighten all screws securely.
© 2022 Monte Carlo Fan Collections
OUTET BOX
Ground/
Green
Brown
Grey
Blue
11
Pass the wifi antenna through the notch
on the mounting plate and reach outside
of the fan housing corresponding to the
installation steps 13 and 14, and then
stick/fix it onto ceiling as shown in
illustration on the installtion step 14.
Receiver
12
Wi-Fi antenna
Notch
Loosen 2 screws across from each other
and remove the other 2 preassembled
screws from side of mounting plate
(corresponding to installation step 13).
Save screws for later use.
4
8/2022