Table of Contents
Advertisement
5
Operating the touch screen
Plug and play (Microsoft Windows 7 and Windows Vista)
When you connect the USB cable between the monitor and a computer with Microsoft Windows 7
and Windows Vista operating system, the Windows touch driver software will automatically install.
The software may take a few minutes to install and a message will be displayed on the lower right
corner of the screen indicating that the driver software has been installed successfully. Once you
install the touch driver, you can select, launch, and drag objects using the touch screen. To make a
selection, touch the screen. The touch driver installation program will not install drivers for Microsoft
Windows Vista or Microsoft Windows 7 operating system. Microsoft plug-and-play touch drivers are
already included in those operating systems for these monitors.
NOTE:
Refer to
connecting the USB cable.
Touch software installation for Microsoft Windows XP
It is recommended that you install MultiTouch Platform software to achieve the best touch
performance. HP recommends that you use a Dual Core 2.5GHz PC for best touch performance.
Installing the software from the CD
The CD that comes with digital signage displays contains files that you can install to communicate
with the touch screen and use the touch screen with Windows applications.
To install the touch driver from the CD:
1.
Insert the CD in the media player/computer.
2.
Click Install MultiTouch Platform. To continue, click Next and follow the instructions on the
screen to install the touch driver.
3.
After setup has finished installing the touch driver, select Yes to restart and click Finish.
4.
Connect the Touch screen display cable (USB) to your PC.
After installing the touch driver, connecting the USB cable, and restarting your computer, the Found
New Hardware Wizard is displayed to complete the driver installation. To install the IR Touch Device
Driver:
1.
Select Yes and click Next to continue and follow the instructions on the screen.
2.
If a Hardware Installation warning displays about the driver not passing Windows Logo testing,
click Continue Anyway.
3.
When prompted that files are needed from the IR Touch Controller Installation Disk, browse to
the location of the file and click OK.
4.
When the wizard finishes installing the software, click Finish to close the wizard.
ENWW
Connecting the USB (Universal Serial Bus) cable on page 25
Plug and play (Microsoft Windows 7 and Windows Vista)
for instructions on
41
Advertisement
Table of Contents
