Operating The Touch Screen; Plug And Play (Microsoft Windows 7 And Windows Vista); Touch Software Installation For Microsoft Windows Xp; Installing The Software From The Cd - HP LD4200TM User Manual

5

Operating the Touch Screen

Plug and Play (Microsoft Windows 7 and Windows Vista)

When you connect the USB cable between the monitor and a computer with Microsoft Windows 7 or
Windows Vista operating system, the Windows touch driver software will automatically install. The
software may take a few minutes to install and a message will be displayed on the lower right corner
of the screen indicating that the driver software has been installed successfully. Once you install the
touch driver, you can select, launch, and drag objects using the touch screen. To make a selection,
touch the screen. The touch driver installation program will not install drivers for Microsoft Windows
Vista or Microsoft Windows 7 operating system. Microsoft plug-and-play touch drivers are already
included in those operating systems for these monitors.
NOTE: Refer to
instructions on connecting the USB cable.
To verify that the touch driver is installed, on the Windows 7 desktop go to Start > Control Panel >
System and Security > System and ensure that Pen and Touch Input Available with 2 Touch
Points is listed in the System section.

Touch Software Installation for Microsoft Windows XP

For the touch screen to function properly when using the Microsoft Windows XP operating system,
you must install the driver.
NOTE: You do not need to install the software for Microsoft Windows 7 or Windows Vista.

Installing the Software from the CD

The CD that comes with LD4200tm monitor contains files that you can install to communicate with the
touch screen and use the touch screen with Windows applications.
To install the touch driver from the CD:
1. Insert the CD in the computer CD-ROM.
2. Click Install Touch Driver. To continue, click Next and follow the instructions on the screen to
install the touch driver.
3. After setup has finished installing the touch driver, select Yes to restart and click Finish.
4. Connect the Touch screen monitor cable (USB) to your PC.
ENWW
Connecting the USB (Universal Serial Bus) Cable on page 18
Plug and Play (Microsoft Windows 7 and Windows Vista)
for illustrated
31